blog/forum

Welcome to our blog/forum!

Welcome to our Blog/Forum

Please take the following into account:

  • We encourage users to post relevant, useful content, as per the list of forum categories. New categories would be acceptable.
  • Please use sound judgement when qualifying posts.
  • If you see content that you think violates these guidelines, submit it for review.
  • We reserve the right to remove any post at our sole discretion.
  • Users are not permitted to like their own posts. Identifying acceptable and complying content as unacceptable, and/or Identifying unacceptable and noncomplying content as acceptable, can affect your user reputation.

Please, check the SheetMetalPatternsOnline.com Forum Community Guidelines, for acceptable and unacceptable content and practices.

Thank you!

Pick a category to show the posts:


Our SheetMetalPatternsOnline.com posts:

Hi!

This is another detailed article of a series on the different welding methods that can be available in a sheet metal fabrication workshop. In this article, TIG.

Tungsten inert gas (TIG) welding, also known as gas tungsten arc welding (GTAW), is a welding process commonly used in sheet meta ...
See more...

   2023-04-11
    Admin
    Sentrupert, Dolenjska - si

Hi!

On occasion, it may be necessary to add conical holes, known as countersinks, to your sheet metal parts.

When it comes to countersinks, there are three essential measurements to consider: major (diameter at the top of the opening, where the screw head will sit), minor (the smaller diameter ...
See more...

   2023-04-06
    LITIO.SI
    Moravce, Gorenjska - si

Hi!

In this post we will provide some general guidelines about the factors that need to be taken into consideration to get a quality weld in sheet metal fabrication.

Proper preparation of the workpieces is important for successful welding. Here are some general guidelines for preparing workpie ...
See more...

   2023-04-04
    LITIO
    Portoroz, Primorska - si

Hi!

In our post on the different type of welding methods we have skipped/forgotten SAW.

Submerged Arc Welding (SAW) is a welding process that involves the formation of a weld by melting the workpiece and a filler metal, while a layer of granular flux shields the weld from the surrounding atmos ...
See more...

   2023-04-01
    LITIO
    Portoroz, Primorska - si

Hi!

Continuing with the topic of our last post:

DIN 6935 is a standard that specifies the minimum bend radius for sheet metal based on the thickness of the material. The standard provides guidelines for determining the minimum bend radius for various sheet metal materials.

The minimal allow ...
See more...

   2023-03-30
    LITIO
    Portoroz, Primorska - si


Pagination